config ARM_GIC select IRQ_DOMAIN select MULTI_IRQ_HANDLER bool config GIC_NON_BANKED bool config ARM_VIC select IRQ_DOMAIN select MULTI_IRQ_HANDLER bool config ARM_VIC_NR int default 4 if ARCH_S5PV210 default 3 if ARCH_S5PC100 default 2 depends on ARM_VIC help The maximum number of VICs available in the system, for power management. config ICST bool config SA1111 bool select DMABOUNCE if !ARCH_PXA config DMABOUNCE bool select ZONE_DMA config SHARP_LOCOMO bool config SHARP_PARAM bool config SHARP_SCOOP bool config FIQ_GLUE bool select FIQ config FIQ_DEBUGGER bool "FIQ Mode Serial Debugger" select FIQ select FIQ_GLUE default n help The FIQ serial debugger can accept commands even when the kernel is unresponsive due to being stuck with interrupts disabled. config FIQ_DEBUGGER_NO_SLEEP bool "Keep serial debugger active" depends on FIQ_DEBUGGER default n help Enables the serial debugger at boot. Passing fiq_debugger.no_sleep on the kernel commandline will override this config option. config FIQ_DEBUGGER_WAKEUP_IRQ_ALWAYS_ON bool "Don't disable wakeup IRQ when debugger is active" depends on FIQ_DEBUGGER default n help Don't disable the wakeup irq when enabling the uart clock. This will cause extra interrupts, but it makes the serial debugger usable with on some MSM radio builds that ignore the uart clock request in power collapse. config FIQ_DEBUGGER_CONSOLE bool "Console on FIQ Serial Debugger port" depends on FIQ_DEBUGGER default n help Enables a console so that printk messages are displayed on the debugger serial port as the occur. config FIQ_DEBUGGER_CONSOLE_DEFAULT_ENABLE bool "Put the FIQ debugger into console mode by default" depends on FIQ_DEBUGGER_CONSOLE default n help If enabled, this puts the fiq debugger into console mode by default. Otherwise, the fiq debugger will start out in debug mode.