1. 根目录:
2. Documentation
3. devicetree
4. bindings
5. regulator
6. max8952.txt

Maxim MAX8952 voltage regulator

Required properties:
- compatible: must be equal to "maxim,max8952"
- reg: I2C slave address, usually 0x60
- max8952,dvs-mode-microvolt: array of 4 integer values defining DVS voltages
  in microvolts. All values must be from range <770000, 1400000>
- any required generic properties defined in regulator.txt

Optional properties:
- max8952,vid-gpios: array of two GPIO pins used for DVS voltage selection
- max8952,en-gpio: GPIO used to control enable status of regulator
- max8952,default-mode: index of default DVS voltage, from <0, 3> range
- max8952,sync-freq: sync frequency, must be one of following values:
    - 0: 26 MHz
    - 1: 13 MHz
    - 2: 19.2 MHz
  Defaults to 26 MHz if not specified.
- max8952,ramp-speed: voltage ramp speed, must be one of following values:
    - 0: 32mV/us
    - 1: 16mV/us
    - 2: 8mV/us
    - 3: 4mV/us
    - 4: 2mV/us
    - 5: 1mV/us
    - 6: 0.5mV/us
    - 7: 0.25mV/us
  Defaults to 32mV/us if not specified.
- any available generic properties defined in regulator.txt

Example:

	vdd_arm_reg: pmic@60 {
		compatible = "maxim,max8952";
		reg = <0x60>;

		/* max8952-specific properties */
		max8952,vid-gpios = <&gpx0 3 0>, <&gpx0 4 0>;
		max8952,en-gpio = <&gpx0 1 0>;
		max8952,default-mode = <0>;
		max8952,dvs-mode-microvolt = <1250000>, <1200000>,
						<1050000>, <950000>;
		max8952,sync-freq = <0>;
		max8952,ramp-speed = <0>;

		/* generic regulator properties */
		regulator-name = "vdd_arm";
		regulator-min-microvolt = <770000>;
		regulator-max-microvolt = <1400000>;
		regulator-always-on;
		regulator-boot-on;
	};