1. 根目录:
2. Documentation
3. devicetree
4. bindings
5. pci
6. designware-pcie.txt

* Synopsys Designware PCIe interface

Required properties:
- compatible: should contain "snps,dw-pcie" to identify the core.
- reg: Should contain the configuration address space.
- reg-names: Must be "config" for the PCIe configuration space.
    (The old way of getting the configuration address space from "ranges"
    is deprecated and should be avoided.)
- #address-cells: set to <3>
- #size-cells: set to <2>
- device_type: set to "pci"
- ranges: ranges for the PCI memory and I/O regions
- #interrupt-cells: set to <1>
- interrupt-map-mask and interrupt-map: standard PCI properties
	to define the mapping of the PCIe interface to interrupt
	numbers.
- num-lanes: number of lanes to use
- clocks: Must contain an entry for each entry in clock-names.
	See ../clocks/clock-bindings.txt for details.
- clock-names: Must include the following entries:
	- "pcie"
	- "pcie_bus"

Optional properties:
- reset-gpio: gpio pin number of power good signal
- bus-range: PCI bus numbers covered (it is recommended for new devicetrees to
  specify this property, to keep backwards compatibility a range of 0x00-0xff
  is assumed if not present)