1. 根目录:
2. Documentation
3. devicetree
4. bindings
5. ata
6. ahci-st.txt

STMicroelectronics STi SATA controller

This binding describes a SATA device.

Required properties:
 - compatible	   : Must be "st,sti-ahci"
 - reg		   : Physical base addresses and length of register sets
 - interrupts	   : Interrupt associated with the SATA device
 - interrupt-names :   Associated name must be; "hostc"
 - resets	   : The power-down and soft-reset lines of SATA IP
 - reset-names	   :   Associated names must be; "pwr-dwn" and "sw-rst"
 - clocks	   : The phandle for the clock
 - clock-names	   :   Associated name must be; "ahci_clk"
 - phys		   : The phandle for the PHY device
 - phy-names	   :   Associated name must be; "ahci_phy"

Example:

	sata0: sata@fe380000 {
		compatible      = "st,sti-ahci";
		reg             = <0xfe380000 0x1000>;
		interrupts      = <GIC_SPI 157 IRQ_TYPE_NONE>;
		interrupt-names = "hostc";
		phys	        = <&miphy365x_phy MIPHY_PORT_0 MIPHY_TYPE_SATA>;
		phy-names       = "ahci_phy";
		resets	        = <&powerdown STIH416_SATA0_POWERDOWN>,
				  <&softreset STIH416_SATA0_SOFTRESET>;
		reset-names     = "pwr-dwn", "sw-rst";
		clocks	        = <&clk_s_a0_ls CLK_ICN_REG>;
		clock-names     = "ahci_clk";
	};