/*
* Copyright (c) 2008, Google Inc.
* All rights reserved.
*
* Redistribution and use in source and binary forms, with or without
* modification, are permitted provided that the following conditions
* are met:
* * Redistributions of source code must retain the above copyright
* notice, this list of conditions and the following disclaimer.
* * Redistributions in binary form must reproduce the above copyright
* notice, this list of conditions and the following disclaimer in
* the documentation and/or other materials provided with the
* distribution.
*
* THIS SOFTWARE IS PROVIDED BY THE COPYRIGHT HOLDERS AND CONTRIBUTORS
* "AS IS" AND ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT
* LIMITED TO, THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS
* FOR A PARTICULAR PURPOSE ARE DISCLAIMED. IN NO EVENT SHALL THE
* COPYRIGHT OWNER OR CONTRIBUTORS BE LIABLE FOR ANY DIRECT, INDIRECT,
* INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIAL DAMAGES (INCLUDING,
* BUT NOT LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS OR SERVICES; LOSS
* OF USE, DATA, OR PROFITS; OR BUSINESS INTERRUPTION) HOWEVER CAUSED
* AND ON ANY THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT LIABILITY,
* OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY OUT
* OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY OF
* SUCH DAMAGE.
*/
#ifndef __ASM_ARCH_MSM7200_GPIO_H
#define __ASM_ARCH_MSM7200_GPIO_H
#define MSM_GPIO1_BASE 0xA9200000
#define MSM_GPIO2_BASE 0xA9300000
/* see 80-VA736-2 Rev C pp 695-751
**
** These are actually the *shadow* gpio registers, since the
** real ones (which allow full access) are only available to the
** ARM9 side of the world.
**
** Since the _BASE need to be page-aligned when we're mapping them
** to virtual addresses, adjust for the additional offset in these
** macros.
*/
#define GPIO1_REG(off) (MSM_GPIO1_BASE + 0x800 + (off))
#define GPIO2_REG(off) (MSM_GPIO2_BASE + 0xC00 + (off))
/* output value */
#define GPIO_OUT_0 GPIO1_REG(0x00) /* gpio 15-0 */
#define GPIO_OUT_1 GPIO2_REG(0x00) /* gpio 42-16 */
#define GPIO_OUT_2 GPIO1_REG(0x04) /* gpio 67-43 */
#define GPIO_OUT_3 GPIO1_REG(0x08) /* gpio 94-68 */
#define GPIO_OUT_4 GPIO1_REG(0x0C) /* gpio 106-95 */
/* same pin map as above, output enable */
#define GPIO_OE_0 GPIO1_REG(0x10)
#define GPIO_OE_1 GPIO2_REG(0x08)
#define GPIO_OE_2 GPIO1_REG(0x14)
#define GPIO_OE_3 GPIO1_REG(0x18)
#define GPIO_OE_4 GPIO1_REG(0x1C)
/* same pin map as above, input read */
#define GPIO_IN_0 GPIO1_REG(0x34)
#define GPIO_IN_1 GPIO2_REG(0x20)
#define GPIO_IN_2 GPIO1_REG(0x38)
#define GPIO_IN_3 GPIO1_REG(0x3C)
#define GPIO_IN_4 GPIO1_REG(0x40)
/* same pin map as above, 1=edge 0=level interrup */
#define GPIO_INT_EDGE_0 GPIO1_REG(0x60)
#define GPIO_INT_EDGE_1 GPIO2_REG(0x50)
#define GPIO_INT_EDGE_2 GPIO1_REG(0x64)
#define GPIO_INT_EDGE_3 GPIO1_REG(0x68)
#define GPIO_INT_EDGE_4 GPIO1_REG(0x6C)
/* same pin map as above, 1=positive 0=negative */
#define GPIO_INT_POS_0 GPIO1_REG(0x70)
#define GPIO_INT_POS_1 GPIO2_REG(0x58)
#define GPIO_INT_POS_2 GPIO1_REG(0x74)
#define GPIO_INT_POS_3 GPIO1_REG(0x78)
#define GPIO_INT_POS_4 GPIO1_REG(0x7C)
/* same pin map as above, interrupt enable */
#define GPIO_INT_EN_0 GPIO1_REG(0x80)
#define GPIO_INT_EN_1 GPIO2_REG(0x60)
#define GPIO_INT_EN_2 GPIO1_REG(0x84)
#define GPIO_INT_EN_3 GPIO1_REG(0x88)
#define GPIO_INT_EN_4 GPIO1_REG(0x8C)
/* same pin map as above, write 1 to clear interrupt */
#define GPIO_INT_CLEAR_0 GPIO1_REG(0x90)
#define GPIO_INT_CLEAR_1 GPIO2_REG(0x68)
#define GPIO_INT_CLEAR_2 GPIO1_REG(0x94)
#define GPIO_INT_CLEAR_3 GPIO1_REG(0x98)
#define GPIO_INT_CLEAR_4 GPIO1_REG(0x9C)
/* same pin map as above, 1=interrupt pending */
#define GPIO_INT_STATUS_0 GPIO1_REG(0xA0)
#define GPIO_INT_STATUS_1 GPIO2_REG(0x70)
#define GPIO_INT_STATUS_2 GPIO1_REG(0xA4)
#define GPIO_INT_STATUS_3 GPIO1_REG(0xA8)
#define GPIO_INT_STATUS_4 GPIO1_REG(0xAC)
#endif