#ifndef _EPIC100_H_
# define _EPIC100_H_
#ifndef PCI_VENDOR_SMC
# define PCI_VENDOR_SMC 0x10B8
#endif
#ifndef PCI_DEVICE_SMC_EPIC100
# define PCI_DEVICE_SMC_EPIC100 0x0005
#endif
#define PCI_DEVICE_ID_NONE 0xFFFF
/* Offsets to registers (using SMC names). */
enum epic100_registers {
COMMAND= 0, /* Control Register */
INTSTAT= 4, /* Interrupt Status */
INTMASK= 8, /* Interrupt Mask */
GENCTL = 0x0C, /* General Control */
NVCTL = 0x10, /* Non Volatile Control */
EECTL = 0x14, /* EEPROM Control */
TEST = 0x1C, /* Test register: marked as reserved (see in source code) */
CRCCNT = 0x20, /* CRC Error Counter */
ALICNT = 0x24, /* Frame Alignment Error Counter */
MPCNT = 0x28, /* Missed Packet Counter */
MMCTL = 0x30, /* MII Management Interface Control */
MMDATA = 0x34, /* MII Management Interface Data */
MIICFG = 0x38, /* MII Configuration */
IPG = 0x3C, /* InterPacket Gap */
LAN0 = 0x40, /* MAC address. (0x40-0x48) */
IDCHK = 0x4C, /* BoardID/ Checksum */
MC0 = 0x50, /* Multicast filter table. (0x50-0x5c) */
RXCON = 0x60, /* Receive Control */
TXCON = 0x70, /* Transmit Control */
TXSTAT = 0x74, /* Transmit Status */
PRCDAR = 0x84, /* PCI Receive Current Descriptor Address */
PRSTAT = 0xA4, /* PCI Receive DMA Status */
PRCPTHR= 0xB0, /* PCI Receive Copy Threshold */
PTCDAR = 0xC4, /* PCI Transmit Current Descriptor Address */
ETHTHR = 0xDC /* Early Transmit Threshold */
};
/* Command register (CR_) bits */
#define CR_STOP_RX (0x00000001)
#define CR_START_RX (0x00000002)
#define CR_QUEUE_TX (0x00000004)
#define CR_QUEUE_RX (0x00000008)
#define CR_NEXTFRAME (0x00000010)
#define CR_STOP_TX_DMA (0x00000020)
#define CR_STOP_RX_DMA (0x00000040)
#define CR_TX_UGO (0x00000080)
/* Interrupt register bits. NI means No Interrupt generated */
#define INTR_RX_THR_STA (0x00400000) /* rx copy threshold status NI */
#define INTR_RX_BUFF_EMPTY (0x00200000) /* rx buffers empty. NI */
#define INTR_TX_IN_PROG (0x00100000) /* tx copy in progess. NI */
#define INTR_RX_IN_PROG (0x00080000) /* rx copy in progress. NI */
#define INTR_TXIDLE (0x00040000) /* tx idle. NI */
#define INTR_RXIDLE (0x00020000) /* rx idle. NI */
#define INTR_INTR_ACTIVE (0x00010000) /* Interrupt active. NI */
#define INTR_RX_STATUS_OK (0x00008000) /* rx status valid. NI */
#define INTR_PCI_TGT_ABT (0x00004000) /* PCI Target abort */
#define INTR_PCI_MASTER_ABT (0x00002000) /* PCI Master abort */
#define INTR_PCI_PARITY_ERR (0x00001000) /* PCI adress parity error */
#define INTR_PCI_DATA_ERR (0x00000800) /* PCI data parity error */
#define INTR_RX_THR_CROSSED (0x00000400) /* rx copy threshold crossed */
#define INTR_CNTFULL (0x00000200) /* Counter overflow */
#define INTR_TXUNDERRUN (0x00000100) /* tx underrun. */
#define INTR_TXEMPTY (0x00000080) /* tx queue empty */
#define INTR_TX_CH_COMPLETE (0x00000040) /* tx chain complete */
#define INTR_TXDONE (0x00000020) /* tx complete (w or w/o err) */
#define INTR_RXERROR (0x00000010) /* rx error (CRC) */
#define INTR_RXOVERFLOW (0x00000008) /* rx buffer overflow */
#define INTR_RX_QUEUE_EMPTY (0x00000004) /* rx queue empty. */
#define INTR_RXHEADER (0x00000002) /* header copy complete */
#define INTR_RXDONE (0x00000001) /* Receive copy complete */
#define INTR_CLEARINTR (0x00007FFF)
#define INTR_VALIDBITS (0x007FFFFF)
#define INTR_DISABLE (0x00000000)
#define INTR_CLEARERRS (0x00007F18)
#define INTR_ABNINTR (INTR_CNTFULL | INTR_TXUNDERRUN | INTR_RXOVERFLOW)
/* General Control (GC_) bits */
#define GC_SOFT_RESET (0x00000001)
#define GC_INTR_ENABLE (0x00000002)
#define GC_SOFT_INTR (0x00000004)
#define GC_POWER_DOWN (0x00000008)
#define GC_ONE_COPY (0x00000010)
#define GC_BIG_ENDIAN (0x00000020)
#define GC_RX_PREEMPT_TX (0x00000040)
#define GC_TX_PREEMPT_RX (0x00000080)
/*
* Receive FIFO Threshold values
* Control the level at which the PCI burst state machine
* begins to empty the receive FIFO. Possible values: 0-3
*
* 0 => 32, 1 => 64, 2 => 96 3 => 128 bytes.
*/
#define GC_RX_FIFO_THR_32 (0x00000000)
#define GC_RX_FIFO_THR_64 (0x00000100)
#define GC_RX_FIFO_THR_96 (0x00000200)
#define GC_RX_FIFO_THR_128 (0x00000300)
/* Memory Read Control (MRC_) values */
#define GC_MRC_MEM_READ (0x00000000)
#define GC_MRC_READ_MULT (0x00000400)
#define GC_MRC_READ_LINE (0x00000800)
#define GC_SOFTBIT0 (0x00001000)
#define GC_SOFTBIT1 (0x00002000)
#define GC_RESET_PHY (0x00004000)
/* Definitions of the Receive Control (RC_) register bits */
#define RC_SAVE_ERRORED_PKT (0x00000001)
#define RC_SAVE_RUNT_FRAMES (0x00000002)
#define RC_RCV_BROADCAST (0x00000004)
#define RC_RCV_MULTICAST (0x00000008)
#define RC_RCV_INVERSE_PKT (0x00000010)
#define RC_PROMISCUOUS_MODE (0x00000020)
#define RC_MONITOR_MODE (0x00000040)
#define RC_EARLY_RCV_ENABLE (0x00000080)
/* description of the rx descriptors control bits */
#define RD_FRAGLIST (0x0001) /* Desc points to a fragment list */
#define RD_LLFORM (0x0002) /* Frag list format */
#define RD_HDR_CPY (0x0004) /* Desc used for header copy */
/* Definition of the Transmit CONTROL (TC) register bits */
#define TC_EARLY_TX_ENABLE (0x00000001)
/* Loopback Mode (LM_) Select valuesbits */
#define TC_LM_NORMAL (0x00000000)
#define TC_LM_INTERNAL (0x00000002)
#define TC_LM_EXTERNAL (0x00000004)
#define TC_LM_FULL_DPX (0x00000006)
#define TX_SLOT_TIME (0x00000078)
/* Bytes transferred to chip before transmission starts. */
#define TX_FIFO_THRESH 128 /* Rounded down to 4 byte units. */
/* description of rx descriptors status bits */
#define RRING_PKT_INTACT (0x0001)
#define RRING_ALIGN_ERR (0x0002)
#define RRING_CRC_ERR (0x0004)
#define RRING_MISSED_PKT (0x0008)
#define RRING_MULTICAST (0x0010)
#define RRING_BROADCAST (0x0020)
#define RRING_RECEIVER_DISABLE (0x0040)
#define RRING_STATUS_VALID (0x1000)
#define RRING_FRAGLIST_ERR (0x2000)
#define RRING_HDR_COPIED (0x4000)
#define RRING_OWN (0x8000)
/* error summary */
#define RRING_ERROR (RRING_ALIGN_ERR|RRING_CRC_ERR)
/* description of tx descriptors status bits */
#define TRING_PKT_INTACT (0x0001) /* pkt transmitted. */
#define TRING_PKT_NONDEFER (0x0002) /* pkt xmitted w/o deferring */
#define TRING_COLL (0x0004) /* pkt xmitted w collisions */
#define TRING_CARR (0x0008) /* carrier sense lost */
#define TRING_UNDERRUN (0x0010) /* DMA underrun */
#define TRING_HB_COLL (0x0020) /* Collision detect Heartbeat */
#define TRING_WIN_COLL (0x0040) /* out of window collision */
#define TRING_DEFERRED (0x0080) /* Deferring */
#define TRING_COLL_COUNT (0x0F00) /* collision counter (mask) */
#define TRING_COLL_EXCESS (0x1000) /* tx aborted: excessive colls */
#define TRING_OWN (0x8000) /* desc ownership bit */
/* error summary */
#define TRING_ABORT (TRING_COLL_EXCESS|TRING_WIN_COLL|TRING_UNDERRUN)
#define TRING_ERROR (TRING_DEFERRED|TRING_WIN_COLL|TRING_UNDERRUN|TRING_CARR/*|TRING_COLL*/ )
/* description of the tx descriptors control bits */
#define TD_FRAGLIST (0x0001) /* Desc points to a fragment list */
#define TD_LLFORM (0x0002) /* Frag list format */
#define TD_IAF (0x0004) /* Generate Interrupt after tx */
#define TD_NOCRC (0x0008) /* No CRC generated */
#define TD_LASTDESC (0x0010) /* Last desc for this frame */
#endif /* _EPIC100_H_ */