# SPDX-License-Identifier: GPL-2.0+ # # Copyright (C) 2015, Bin Meng <bmeng.cn@gmail.com> config INTEL_QUARK bool select HAVE_RMU select ARCH_EARLY_INIT_R select ARCH_MISC_INIT imply ENABLE_MRC_CACHE imply ETH_DESIGNWARE imply ICH_SPI imply INTEL_ICH6_GPIO imply MMC imply MMC_PCI imply MMC_SDHCI imply MMC_SDHCI_SDMA imply SPI_FLASH imply SYS_NS16550 imply USB imply USB_EHCI_HCD if INTEL_QUARK config HAVE_RMU bool "Add a Remote Management Unit (RMU) binary" help Select this option to add a Remote Management Unit (RMU) binary to the resulting U-Boot image. It is a data block (up to 64K) of machine-specific code which must be put in the flash for the RMU within the Quark SoC processor to access when powered up before system BIOS is executed. config RMU_FILE string "Remote Management Unit (RMU) binary filename" depends on HAVE_RMU default "rmu.bin" help The filename of the file to use as Remote Management Unit (RMU) binary in the board directory. config RMU_ADDR hex "Remote Management Unit (RMU) binary location" depends on HAVE_RMU default 0xfff00000 help The location of the RMU binary is determined by a strap. It must be put in flash at a location matching the strap-determined base address. The default base address of 0xfff00000 indicates that the binary must be located at offset 0 from the beginning of a 1MB flash device. config HAVE_CMC bool default HAVE_RMU config CMC_FILE string depends on HAVE_CMC default RMU_FILE config CMC_ADDR hex depends on HAVE_CMC default RMU_ADDR config ESRAM_BASE hex default 0x80000000 help Embedded SRAM (eSRAM) memory-mapped base address. config PCIE_ECAM_BASE hex default 0xe0000000 config RCBA_BASE hex default 0xfed1c000 help Root Complex register block memory-mapped base address. config ACPI_PM1_BASE hex default 0x1000 help ACPI Power Managment 1 (PM1) i/o-mapped base address. This device is defined in ACPI specification, with 16 bytes in size. config ACPI_PBLK_BASE hex default 0x1010 help ACPI Processor Block (PBLK) i/o-mapped base address. This device is defined in ACPI specification, with 16 bytes in size. config SPI_DMA_BASE hex default 0x1020 help SPI DMA i/o-mapped base address. config GPIO_BASE hex default 0x1080 help GPIO i/o-mapped base address. config ACPI_GPE0_BASE hex default 0x1100 help ACPI General Purpose Event 0 (GPE0) i/o-mapped base address. This device is defined in ACPI specification, with 64 bytes in size. config WDT_BASE hex default 0x1140 help Watchdog timer i/o-mapped base address. config SYS_CAR_ADDR hex default ESRAM_BASE config SYS_CAR_SIZE hex default 0x8000 help Space in bytes in eSRAM used as Cache-As-ARM (CAR). Note this size must not exceed eSRAM's total size. endif